Service Tests and Utilities

7The Front Panel then prompts you to remove the Setup Printheads and install the Printheads.

8Remove ALL the Setup Printheads from the Carriage and install the previously removed Printheads.

9Once ALL the Printheads are installed, the Front Panel will instruct you to close the Carriage cover and close the Window.

10The Printer will now perform the Printhead Alignment and Front Panel will prompt you to continue with the Printhead Alignment, select Align now and press the OK key.

11Once the Printhead Alignment is completed, the following message will be displayed on the Front Panel. Press the OK key to continue.

3. Set SN

The purpose of this Service Utility is to set the Serial Number of the Printer.

Perform the Set SN utility as follows:

1In the Service Utilities submenu, scroll to Set SN and press OK.

3-62

HP Designjet T Series — Service Manual