Service Tests (Diagnostics)
Uncapping Service Station.
Starting Cutter.
Starting PaperMotor.
Starting Media Sensor.
Reading Media Presence.
5If paper is already loaded, the printer detects the paper and continues the test. If paper is NOT loaded, the Front Panel prompts you to load roll media.
6Raise the Media Lever, load roll media, lower the Media Lever, and press any key to continue.
7The printer then starts an actual test cut of the media. As the test executes the Front Panel displays the following messages:
Advance paper.
Engaging cutter.
Cutting paper.
Disengaging cutter.
8Once the test has completed the Front Panel displays the test result and prompts you to confirm that the cutter worked.
9Press OK if the cutter worked or BACK/CANCEL if the cutter did NOT work.
.
10The Front Panel shows the test complete display for a few seconds.
HP Designjet T Series — Service Manual |