Removal and Installation - Encoder Strip

Encoder Strip

The Encoder Strip removal procedure for the T1100/T1100ps/T610 and T1120/T1120ps printers is the same.

The part numbers are different. For information about the T1100/T1100ps/T610 Encoder Strip service parts, see Scan-Axis Assemblies (T1100/T1100ps/T610) on page 5-20.

For information about the T1120/T1120ps Encoder Strip service parts, see Scan-Axis Assemblies (T1120/T1120ps) on page 5-22.

Removal

Switch off the printer and remove the power cable.

1. Remove the Right Cover on page 6-27.2. Remove the Left Cover on page 6-30.

3. Remove the Encoder Strip, spring, and attachment nut. See page 6-96 or 6-99 depending on the model.

4. Use the spanner provided in the tool kit to remove the 13 mm locking nut that secures the Encoder Strip to the Encoder Strip Spring.

5. Remove the Encoder Strip Spring.

When you finish installing or replacing this component, you must perform the necessary Service Calibrations. To find which calibrations you must perform, see Service Calibration Guide to Removal and Installation on page 6-5.

HP Designjet T Series — Service Manual

6-101