Removal and Installation - Scan-Axis Motor (T1120/T1120ps)

11. Remove three T-15 screws that secure the Scan-Axis Motor to the printer.

12. Carefully pull the Scan-Axis Motor out of the printer (10 mm) until you can rotate it approximately 30 degrees counterclockwise.

2

1

13. Remove the Scan-Axis Motor from the printer.

When you finish installing or replacing this component, you must perform the necessary Service Calibrations. To find which calibrations you must perform, see Service Calibration Guide to Removal and Installation on page 6-5.

HP Designjet T Series — Service Manual

6-149