Removal and Installation

Left Roll Guide

Removal

Switch off the printer and remove the power cable.

1. Remove the Spindle on page 6-79.

2. Remove the Clean Out Assembly on page

6-90.

3. Remove five T-15 screws that secure Left Roll Guide to the printer.

4. Lower the left end and remove the Left Roll Guide from the printer.

When you finish installing or replacing this component, you must perform the necessary Service Calibrations. To find which calibrations you must perform, see Service Calibration Guide to Removal and Installation on page 6-5.

6-94

HP Designjet T Series — Service Manual