Removal and Installation - Starwheel Motor

Starwheel Motor

Removal

Switch off the printer and remove the power cable.

1. Remove the Front Cover on page 6-16.2. Remove the Left Cover on page 6-30.

3. Remove the Electronics Module Main PCA and PSU. See page 6-202or 6-205 depending on the printer model.

4. Remove the Left Spittoon on page 6-214.

5. Disconnect the Starwheel Motor electrical connector.

6. Carefully pull the two gear wheels off their shafts to gain access to the Starwheel Motor attachment screws.

HP Designjet T Series — Service Manual

6-245