Removal and Installation
Carriage Assembly without Trailing Cable shown
40.Remove the Scan Side Panel.
41.Carefully slide the Carriage Assembly and Belt Assembly out of the printer (and the Trailing Cable if you are removing it with the Carriage Assembly).
Before you reinstall the Carriage Assembly use an alcohol dampened cloth to remove all traces of residual adhesive remaining from the double sided pads removed earlier before applying new pads in the same positions as the original pads.
When you reinstall the Carriage Assembly, take care not to damage the PRS Slider.
When you finish installing or replacing this component, you must perform the necessary Service Calibrations. To find which calibrations you must perform, see Service Calibration Guide to Removal and Installation on page
HP Designjet T Series — Service Manual |