System Error Codes

 

7 If the System Error continues, replace the Main PCA. See Starwheel

 

Assembly on page 6-208.

System Error:

41.1:YZ

Problem

Electrical fault or current limit in Media-Axis Motor.

Description:

 

Corrective Action: Try the following:

1Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.

2Open the Window and check for any visible obstacles restricting the movement of the Media Advance Roller. If there is a wrinkled mass of media inside the paper path, lift the Pinch wheels (using Media Lever) and clear the obstruction.

3Perform the Paper Drive diagnostic test to troubleshoot the problem furthe. See 2. Paper Drive on page 3-18.

4If the printer has a 44 inch scan axis (and a Rewinder), perform the Rewinder diagnostic test to troubleshoot the problem further. See 6. Rewinder on page 3-34.

5Check that the Media Advance Drive cable is not damaged and is correctly connected to the Main PCA.

6Replace the Media Advance Drive. See Media Advance Drive on page 6- 218.

7If the System Error continues, replace the Main PCA. See Starwheel Assembly on page 6-208.

System Error:

42:03

Problem

Scan-Axis Motor failure (likely due to obstacles in the scan axis or electrical

Description:

fault).

Corrective Action: Try the following:

 

„ Same as 42:YZ but after testing the issue is repeatable.

System Error:

42:YZ

Problem

Scan-Axis Motor failure (likely due to friction or obstacles in the media path).

Description:

 

Corrective Action: Try the following:

1Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.

2Open the Window and check for any visible obstacles restricting the movement of the Media Advance Roller. If there is a wrinkled mass of media inside the paper path, lift the Pinch wheels (using Media Lever) and clear the obstruction.

3Perform the Scan Axis diagnostic test to troubleshoot the problem further. See 1. Scan Axis on page 3-6.

4Check that there is no obstacle preventing the Service Station from working.

2-16

HP Designjet T Series — Service Manual