System Error Codes

 

System Error:

06:YZ

Problem

Failure reading/writing NVM in Hard disk.

Description:

 

Corrective Action: Try the following:

1Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.

2If the System Error continues, replace the Formatter. See Formatter on page 6-200.

System Error: 08:YZ (T1100/T1100ps/T610 ONLY)

Problem No comunication between the Front Panel and the Main PCA.

Description:

Corrective Action: Try the following:

1Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.

2Check that the Front Panel interface cable is not damaged and is correctly connected between the Main PCA and the Front Panel.

3Check that the connections between the Formatter and the Main PCA are not damaged and are correctly connected.

4If the System Error continues, replace the Formatter. See Formatter on page 6-200.

5If the System Error continues, replace the Main PCA. See Starwheel Assembly on page 6-208.

6If the System Error continues, replace the Front Panel. See Front Panel on page 6-47.

System Error: 08:YZ (T1120/T1120ps ONLY)

Corrective Action: The LEDs of the formatter (visible through the cover) and the power supply can help you troubleshoot a problem when the Front Panel is blank.

The following image shows the Power Supply LED, looking through the cover.

2-10

HP Designjet T Series — Service Manual