Service Calibrations
Perform the Paper Advance Calibration as follows:
Make sure that you unload media from the Printer before performing the Paper Advance Calibration.
1In the Service Calibrations submenu, scroll to “Paper Advance Calibration” and press OK.
2In the Paper Advance Calibration submenu, scroll to Print Calibration Pattern and press OK.
3When the following message appears on the front panel, you must select whether you would like to continue with the calibration by pressing the OK key. Press Back or Cancel to exit the calibration.
4If paper is detected, the printer will prompt you to remove the media. If paper is NOT detected, the calibration will continue.
5The Printer will start to calibrate the Analog Encoder and the following message will be displayed on the Front Panel.
If the Calibration is not done or if the values are out of the limits, a warning message will appear on the Front Panel. In this case, try the following:
Check that the Printer has the latest Firmware version. If not, update the Firmware to the latest version.
HP Designjet T Series — Service Manual |