Sharp MX-M1100, MX-M850, MX-M950 manual 426

				(1)					(2)		Select job build mode.
											(1) Touch the [Job Build] key so that it is
	Scan/Special Modes									OK
											highlighted.
		Program				Erase		Dual Page			(2) Touch the [OK] key.
								Scan
4
										1
			Timer		Suppress		Card Shot			2
					Background
			Job			Mixed Size		Slow Scan
			Build			Original		Mode
			Original			File	Quick File
			Count

Press the [START] key () to scan the first original.

5

To cancel scanning...

Press the [STOP] key () to cancel the operation.

Insert the next set of originals and press the [START] key ().

Repeat until all originals have been scanned.

6

To cancel scanning...

Press the [STOP] key () to cancel the operation. All scanned data will be cleared.

Touch the [Read-End] key.

Place next original.	(Pg.No.x)
Press [Start].
When finished, press [Read-End].
	Configure	Read-End

7

• If no action is taken for one minute after the confirmation screen appears, scanning automatically ends and the transmission is reserved.

•The [Configure] key can be touched to change the exposure, resolution, scan size, and send size for each original page scanned. However, when Job Build is used in combination with "2in1" in the special modes, only the exposure can be changed when scanning each even-numbered page of the original pages.

•If the memory becomes full during scanning, a message will appear and the transmission will be canceled.

• Fax mode:

This function cannot be used in direct transmission mode or when the speaker is used to dial.

To cancel the job build function....

Touch the [Job Build] key in the screen of step 4 so that it is not highlighted.

106