Adjust the original guides to the size of the originals.
2
Indicator line
3
Place the original.
Make sure the edges of the originals are even.
Insert the originals face up all the way into the document feeder tray.
Insert a number of originals that does not exceed the indicator line on the document feeder tray.
Up to 250 sheets can be inserted.
When placing the original, make sure that the guide is correctly adjusted to the width of the original.
If there is a gap between the original and the guide, or if the original is bowed because the guide is adjusted to a narrower width than the paper, a misfeed, skewed original feeding, or creases in the original may result.
•Originals of different sizes can be placed together in the automatic document feeder. In this case, select "Mixed Size Original" in the special modes of the mode you are using. For the procedures for inserting mixed size originals and the sizes that can be inserted, see the Copier Guide and the Image Send Guide.
•Before inserting originals into the document feeder tray, be sure to remove any staples or paper clips.
•If originals have damp spots due to correction fluid, ink or pasteup glue, wait until the originals are dry before making copies. Otherwise the interior of the document feeder or the document glass may be soiled.
•Do not use the following originals. Incorrect original size detection, original misfeeds, and smudges may result. Transparency film, tracing paper, carbon paper, thermal paper or originals printed with thermal transfer ink ribbon should not be fed through the document feeder. Originals to be fed through the feeder should not be damaged, crumpled, folded, loosely pasted together, or have
•When using originals with two or three holes, place them so that
the punched edge is at a position away from the feed slot of the document feeder tray.
Feed slot | Hole |
| |
| positions |
54