2Preparing the Analyzer for Use

To do the incoming inspection 2-5

To install the analyzer 2-7

To connect the analyzer to a dc power source 2-8 To change the fuses 2-10

To connect the analyzer to a serial device 2-11 To connect the analyzer to a parallel device 2-11 To connect the analyzer to an GPIB device 2-12 To connect the analyzer to an external monitor 2-13 To connect the optional keyboard 2-14

To connect the microphone adapter 2-16

To clean the screen 2-17

To store the analyzer 2-17

To transport the analyzer 2-18

If the analyzer will not power up 2-19

If the analyzer operates intermittently on dc power 2-20

3Verifying Specifications

To load the program 3-7

To run the program in semiautomated mode 3-8

To run the program without a printer

3-10

To run the program in manual mode

3-12

To set up the self test 3-13

To set up the dc offset test 3-14

To set up the noise test 3-15

To set up the spurious signals test 3-16

To set up the amplitude accuracy test 3-17

To set up the flatness test 3-18

To set up the amplitude linearity test 3-19

To set up the A-weight filter test 3-20

To set up the channel match test 3-21

To set up the frequency accuracy test 3-22

Page 12
Image 12
Agilent Technologies 35670-90066 manual Preparing the Analyzer for Use