Verifying Specifications

Agilent 35670A

Program Controlled Test Equipment

This program automatically controls the instruments listed in the following table using GPIB commands. If you use a test instrument other than those shown in the table, the program prompts you to set the instrument state during testing.

Test Equipment

Program Controlled Model

 

 

 

 

AC Calibrator

Fluke 5700A

 

Alternate

 

Fluke 5200A

 

Datron 4200, 4707, 4708

 

 

Frequency Synthesizer

HP 3326A

 

Alternate

 

(2) HP 3325A/B

 

 

Digital Multimeter

HP 3458A

 

Alternate

 

HP 3455A

 

HP 3456A

 

HP 3478A

Measurement Uncertainty

A table starting on page 3-56lists the measurement uncertainty and ratio for each performance test using the recommended test equipment. Except for the External Trigger test, the ratios listed for the recommended test equipment meet or exceed the measurement uncertainty ratio required by U.S. MIL-STD-45662A. The table also provides a place to record the measurement uncertainty and ratio for each performance test using equipment other than the recommended test equipment. The table may be reproduced without written permission of Agilent Technologies.

Operation Verification and Performance Tests

The operation verification tests give a high confidence level (>90%) that the Agilent 35670A Dynamic Signal Analyzer is operating properly and within specifications. The operation verification tests are a subset of the performance tests. The operation verification tests should be used for incoming and after-repair inspections. The performance tests provide the highest level of confidence and are used to verify that the Agilent 35670A Dynamic Signal Analyzer conforms to its published specifications. Some repairs require a performance test to be done after the repair (see chapter 6, ‘’Replacing Assemblies’’ in the Agilent 35670A Service Guide for this information). The following table lists the operation verification and performance tests.

3-4

Page 62
Image 62
Agilent Technologies 35670-90066 manual Operation Verification and Performance Tests, Program Controlled Test Equipment