6.4 SoftwareGuide CD-ROM with Windows Terminal Server Edition

When using SoftwareGuide to install Windows NT Server 4.0, Terminal Server Edition, you must copy the necessary device drivers to diskettes and use these diskettes during the installation of Windows NT Server 4.0, Terminal Server Edition. Terminal Server Edition is installed via its diskettes and CD-ROM (you must use the shrink-wrap version).

Note: At the time of writing, ServerGuide does not support Windows NT Server 4.0, Terminal Server Edition.

After using HardwareGuide, you should use SoftwareGuide to prepare your system for the Terminal Server Edition installation. Complete the following steps to create the necessary diskettes:

1.Place the SoftwareGuide CD-ROM into the server and reboot.

2.At the main menu, click Diskette Factory.

3.Under Select a Category, you should see Your Server selected as the default. Click > to continue.

4.Check the packages that appear on the screen. In our example, we used an IBM Netfinity 5000 as our Windows Terminal Server and selected:

IBM Netfinity 5000 System Diskettes

IBM ServeRAID Adapter

Click > to continue.

5.In our example, the diskettes we selected to create from the packages were:

7800 Family Manager Set Disk 1 of 2

IBM ServeRAID Device Driver Diskette

IBM Netfinity S3 Trio V2/GX Device Driver for NT

IBM Netfinity, PC Srvr Ethernet Ctrlr and IBM Netfinity 10/100 Fault Tolerant Dev Drvr.

6.Click > to begin creating your diskettes. After all the diskettes have been completed, click < four times to return to the ServerGuide exit dialog box and click OK.

7.Remove the CD-ROM and then click OK.

8.Continue with the installation of Windows NT Server 4.0, Terminal Server Edition using the diskettes and CD-ROM shipped with the product.

86J.D. Edwards’ OneWorld B73.3 and Windows Terminal Server

Page 98
Image 98
IBM B73.3 manual SoftwareGuide CD-ROM with Windows Terminal Server Edition