Status Messages (continued)
Status messages | Explanation |
Sensor not free | The paper of one of the rolls is transferred after the marker (see |
Remove paper | ‘Feed the material’ on page 155) when power is applied to the |
Press | printer. |
| Take the paper back. |
| Press |
|
|
Paper retracted | Put the paper into the manual feed. |
Press | Press |
|
|
Copy too short | The length of the print material is less than 420 mm. This can oc- |
Remove paper | cur with the manual feed. |
Press | Use an original longer than 420 mm. |
|
|
Inputflap open | The input flap is open. |
Close inputflap | Close the input flap. |
|
|
Inputflap open | The input flap is open during the print process |
Remove paper | Remove the paper and press |
Press |
|
|
|
Roll 1 empty | The paper on roll 1 is empty. |
Open roll unit | Open the roll unit and replace it. |
|
|
Roll 2 empty | The paper on roll 2 is empty. |
Open roll unit | Open the roll unit and replace it. |
|
|
Wait for folder | The communication between the printer and the folder starts up. |
|
|
Folder is off | The communication between the printer and the folder was not es- |
| tablished. |
|
|
Folder belt full | The belt of the folder is full. |
| Empty the belt of the folder. |
|
|
RU tape empty | The tape roll of the reinforcement unit is empty. |
| Open the reinforcement unit and replace the empty tape roll. |
|
|
Using the Océ TDS400 to Print | 43 |
