IBM user manual How to turn on and turn off the Océ TDS400 printer

How to turn on and turn off the Océ TDS400 printer

To turn on the system:

■turn on the printer.

■turn on the scanner (see page 53).

■turn on the controller(see page 28).

When you turn on the system, it is ready for operation. In this state, the machine is in the stand-by mode.

If the system is not in use for more than 1 minute, the operator panel returns automatically to the stand-by mode. The operator panel of the scanner is activated in the following conditions:

■you feed an original

■a key on the operator panel is pressed

▼Turn on the printer

1Set the ON/OFF switch at the rear of the printer to position ‘1’ (see Figure 6). If the power supply is connected, the green switch lights.

[6] On/off switch of the printer

Note: When ‘Ready’ is displayed on the operator panel, the printer is ready for use.

Using the Océ TDS400 to Print 27