Cut media

If the material does not have a straight leading strip, you can cut the material at right angles from the roll.

Cut the material from roll 1 or roll 2

1 Open the drawer.

2 Feed the paper manually until it is 5 cm above the top drawer.

3Press the On-line key to put the printer off-line.

4Close the paper drawer.

5Select the ‘Media settings’ item with the or key.

6Press Next/select to enter the ‘Media settings’ menu.

7Select ‘Cut media’ with the or key.

8Press Next/select to cut the paper.

9Open the paper drawer.

10Remove the scrap of material.

11Feed the material until you can see the material and put the material into position (see Figure 61 on page 155) and (see Figure 65 on page 157).

12Close the drawer.

13Press the On-line key to put the printer on-line again.

32

Océ TDS400 User Manual

Page 32
Image 32
IBM TDS400 user manual Cut media