[63] Remove the roll holder from the lower paper drawer
3Remove the empty core from the roll holder while pressing the knob (see Figure 59 on page 154).
4Slide the roll holder in the roll of print material while pressing the knob (see Figure 59 on page 154).
It is important to have the knob at the right hand side and the paper as shown in figure 59.
5Align the roll with the appropriate lines on the roll holder while you press the knob.
Place the roll holder with the material in the lower paper compartment (see Figure 64).
da
[64] Reposition the roll in the lower paper drawer
6Feed the material between the input guide plates against the rollers.Turn the rollers until the material is visible (see Figure 65). Also refer to the sticker inside the drawer.
156 | Océ TDS400 User Manual |
