Konica Minolta 7075 manual Introduction

Introduction

Features of the Konica 7075 (continued)

• Non STD Size for Multi-Sheet Bypass Tray

Enter the special paper size to be loaded on the Multi-sheet bypass tray using the touch screen keypad in order to avoid paper misfeed.

• Non STD Size for Original

Identify the special original size which the 7075 could not detect in order to select the optimal paper size for copying or printing.

• Output mode for Machine with FS-108/108B Finisher Installed:

Non-Sort, Sort, Staple-Sort, and Group modes using the primary (main) tray Non-Sort Face Down exit, Non-Sort Face Up exit, Group Face Down exit, and Group Face Up exit modes using the secondary (sub) tray

Stapling & Folding, and Folding modes using the booklet tray (FS-108B only) Select an output tray and output mode on the Finisher Mode Selection Screen and on the Control panel. For details of each output mode, see Section 7: Output Modes.

• Output for Machine with no Finisher Installed: Sort and Group modes

Use the default condition to output copies in the same order as the originals. Use the Sort mode to alternately switch the horizontal and vertical orientation of each copied set upon exit. Use the Group mode to output multiple copies of each original without offsetting them upon exit.

•Output mode for FS-108/108B Finisher with PI-108 Cover Sheet Feeder Installed: Cover Sheet mode

Manual Staple mode

For details of each output mode, see Section 7: Output Modes.

• Paper Capacity

Total 2,150 sheets, including two 500-sheet trays, a 1,000-sheet tray, and a 150-sheet Multi Sheet Bypass tray.

Total 6,150 sheets, including 4,000-sheet optional large capacity tray.

• Platen Memory

Scan documents into memory from the platen glass and/or the document feeder and insert the pages into another document copied from the document feeder. If an incompatible function is selected in this mode, the latter function will not be selected, and a Caution message will be displayed.

• Power Saver

Automatically turns off all but nominal power supply after a specified period of copier inactivity, for optimal efficiency. Power is returned after a brief warm up period by pressing [POWER SAVER ON/OFF] key on the Control panel.

1-8 Introduction