Troubleshooting
Memory Overflow
In certain modes, the Konica 7075 uses memory for convenience and to make operations flow smoothly. Occasional memory overflow may occur if the installed memory is inadequate for the copy conditions selected. Should memory overflow occur frequently, it is recommended that you contact your Konica service representative to extend the memory capacity in your machine.
When memory overflow occurs, the following screen will be displayed to enable you to take an appropriate measure for the current job situation.
Memory Overflow Management Screen
When memory overflow occurs while scanning the first job, the machine stops immediately, and the screen provides JOB STOP and SCAN STOP as the only two available options.
NOTE: If the job settings include Booklet mode, SCAN STOP will disappear.
•To delete all the scanned data and discontinue the job, touch JOB STOP.
•To give up further scanning but print out all the data already scanned into memory, touch SCAN STOP.
When memory overflow occurs during the reserve operation, CONTINUE also appears on the active screen. In this case, the machine will not stop until all the jobs on standby for printing are completed.
•To delete the scanned data and discontinue the last reserve job, touch JOB STOP.
•To give up further scanning but print out the data already scanned for the last reserve
job, touch SCAN STOP.
NOTE: If the job settings include Booklet mode, SCAN STOP will disappear.
•To continue scanning the last reserve job, touch CONTINUE as the current printing job gradually enables memory for new data.
