Maintenance & Supplies
Loading Paper (continued)
Loading Tabbed Sheets in Tray 1, 2, or 3
Load offset tabbed sheets so that the tab extensions are on the left at the rear (not front) of the tray.
When loading tabbed sheets in the tray, be sure to specify the paper type as TAB in the Key operator mode; otherwise mishandled paper may occur. See p.
The top sheet is designated face down as the first tab of the finished set. Subsequent offset tab sheets follow in sequence.
Rear
Example: 3 Tabbed sheets loaded in position for one finished set.
| Section 3 |
| 1st TAB | |
Front | Management |
|
| |
Printed | Section 1 | 2nd TAB | ||
| ||||
| side | Introduction | ||
|
|
| ||
|
|
| 3rd TAB | |
| 1st TAB |
|
| |
| 2nd TAB |
|
| |
| 3rd TAB | ONE FINISHED SET | ||
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
Rear
Section 3
Management
Front
Printed side
1st TAB
Section 1
Introduction
2nd TAB
Section 1 | Section 1 |
Introduction | Introduction |
1st TABS
2nd TABS 3rd TABS
3rd TAB
3 FINISHED SETS
Maintenance & Supplies
