Image Send Settings
Settings related to the image send function (scan, Internet fax, etc.) can be configured. Touch the [Image Send Settings] key to configure the settings.
For explanations of settings related to the fax function, see "2. SYSTEM SETTINGS FOR FAX (ADMINISTRATOR)" (page 76).
Operation Settings
The operation settings below apply to all image send functions.
Other Settings
Default Display Settings
You can select one of 5 base screen types for the base screen that appears when the [IMAGE SEND] key is
Initial Resolution Setting
The following settings are available for the default resolutions of scan, Internet fax, and fax mode. Scan : 100X100 dpi, 200X200 dpi, 300X300 dpi,
400X400 dpi, 600X600 dpi Internet fax : 200X100 dpi
touched or when the [CLEAR ALL] ( 
) key is pressed in image send mode.
• Address Book |
• Scan |
• Internet Fax |
• Fax |
200X200 dpi
200X400 dpi
400X400 dpi
600X600 dpi
Fax: Standard
Fine
Half Tone
• Data Entry |
Hold settings for a while after scanning has been completed
Use this setting to hold the settings after scanning is completed (until Auto Clear Mode activates).
Switch Automatically to Copy Mode Screen
Enable this setting to have the screen automatically switch to the copy mode screen if no action is taken in the image send mode screen for 20 seconds.
Super Fine Half Tone
Ultra Fine
Apply the Resolution Set when Stored
When an image stored by document filing is used, this applies the resolution setting that was stored with the image.
Address Book Default Selection
One of the following screens can be specified for the initial address book screen.
Tab Switch
•ABC
•Group
Address Type
•All
•
•FTP/Desktop
•Network Folder
•Internet Fax
•Fax
•Group
53