Siemens 6RA70 specifications 10-6

PNU	Description			Value range	No. indices	See
				[Unit]	Factory	Change
				Steps	setting	(Access /
					Type	Status)
	o7.3	Waiting for completion of "Restore factory settings" operation.
	o7.4	Waiting for switch-on command before execution of an
		optimization run
	o7.5	Wait for completion of "Read in parameter set" operation.
	o7.6	Wait for completion of "Load MLFB" operation (performed at
		factory)
	o7.9	reserved for firmware download for optional supplementary
		modules	[SW 2.0 and later]
	o8	Waiting for acknowledgement of starting lockout
	o8.0	Waiting for acknowledgement of starting lockout through input of
		SHUTDOWN command (OFF1).
	o8.1	Simulation operation active (see under U840) [SW1.7 and later]
	o9	Fast stop (OFF3)
	o9.0	Fast stop has been input via binector (acc. to selection in P658)
		or control word, bit 2 (acc. to selection in P648).
	o9.1	Fast stop has been input via binector (acc. to selection in P659).
	o9.2	Fast stop has been input via binector (acc. to selection in P660).
	o9.3	Fast stop is stored internally (memory can be reset by cancelling
		FAST STOP command and entering SHUTDOWN).
	o10	Voltage disconnection (OFF2)
	o10.0	Voltage disconnection has been input via binector (acc. to
		selection in P655) or control word, bit 1 (acc. to selection in
		P648).
	o10.1	Voltage disconnection has been input via binector (acc. to
		selection in P656).
	o10.2	Voltage disconnection has been input via binector (acc. to
		selection in P657).
	o10.3	E-Stop (safety shutdown) has been input via terminal 105 or 107
	o10.4	Wait for receipt of a valid telegram on G-SST1 (only if telegram
		failure time monitoring is set with P787 ≠ 0)
	o10.5	Waiting for receipt of a valid telegram on G-SST2 (only if
		telegram failure time monitoring is set with P797 ≠ 0)
	o10.6	Waiting for receipt of a valid telegram on G-SST3 (only if
		telegram failure time monitoring is set with P807 ≠ 0)
	o11	Fault
	o11.0	= Fxxx Fault message is displayed, red LED lights up.
	o12	Electronics initialization in progress
	o12.1	Basic converter electronics initialization in progress
	o12.2	Initialization of supplementary board in location 2 in progress
	o12.3	Initialization of supplementary board in location 3 in progress
	o12.9	Restructuring of parameters in non-volatile storage after
		software update (takes approx. 15s)
	o13	Software update in progress
	o13.0	Waiting for arrival of start command from HEXLOAD PC routine
		(press the DOWN key to abort this status and start a RESET)
	o13.1	Deletion of Flash EPROM in progress
	xxxxx	Display of address currently being programmed
	o13.2	The Flash EPROM has been successfully programmed
		(a RESET is performed automatically after approx. 1 second)
	o13.3	Programming of the Flash EPROM has failed
		(press UP key to return to operating state o13.0)
	o14	Loading of boot sector in progress
		(this operation is performed only in factory)
	o15	Electronics not connected to voltage
		Dark display: Waiting for voltage at terminals 5U1, 5W1
		(electronics supply voltage).

10-6	SIEMENS Energy & Automation
	SIMOREG DC Master Base Drive Panel Operating Instructions