Siemens 6RA70 specifications 10-62

PNU	Description	Value range	No. indices	See
		[Unit]	Factory	Change
		Steps	setting	(Access /
			Type	Status)
Speed controller

P609

*

(G151)

Source for actual speed controller value

Selection of connector to be injected as the actual speed controller value when P083=4

0 = connector K0000

1 = connector K0001 etc.

All connector numbers

1

Ind: None

FS=0

Type: L2

P052 = 3

P051 = 40 Offline

Setting values for configuring of closed-loop field and EMF control
			All connector
P610	Source for gating unit input (field)			Ind: None	P052 = 3
*	Selection of connector to be applied to the gating unit input (field)		numbers	FS=252	P051 = 40
(G166)			1	Type: L2	Offline
	0 = connector K0000
	1 = connector K0001
	etc.
P611	Source for field current controller setpoint		All connector	Ind: 4	P052 = 3
*	Limitation at EMF controller output:		numbers	FS=	P051 = 40
(G165)			1	i001: 277	Offline
	Selection of connectors to be injected as the field current controller			i002: 0
	setpoint. The connectors selected in the four indices are added.			i003: 0
	0 = connector K0000			i004: 0
				Type: L2
	1 = connector K0001
	etc.
P612	Source for actual field current controller value		All connector	Ind: 2	P052 = 3
*	Selection of connectors to be injected as the field current controller actual		numbers	FS=	P051 = 40
(G166)			1	i001: 266	Offline
	value. The two values are added.			i002: 0
	0 = connector K0000			Type: L2
	1 = connector K0001
	etc.
P613	Source for variable field current setpoint upper limit		All connector	Ind: 5	P052 = 3
*	Limitation at EMF controller output		numbers	FS=1	P051 = 40
(G165)			1	Type: L2	Offline
	Selection of connector to be injected as the variable field current setpoint
	upper limit
	i001..i004Normalization:
		100% of the connector value corresponds to the rated
		excitation current of the motor (P102)
	i005	Normalization:
		100% of the connector value corresponds to the actual
		converter rated DC current (field) (r073.002)
		[can be set in SW 1.9 and later]
	0 = connector K0000
	1 = connector K0001
	etc.
P614	Source for variable field current setpoint lower limit		All connector	Ind: 5	P052 = 3
*	Limitation at EMF controller output		numbers	FS=1	P051 = 40
(G165)			1	Type: L2	Offline
	Selection of connector to be injected as the variable field current setpoint
	lower limit
	i001..i004Normalization:
		100% of the connector value corresponds to the minimum
		excitation current of the motor (P103)
	i005	Normalization:
		100% of the connector value corresponds to the actual
		converter rated DC current (field) (r073.002)
		[can be set in SW 1.9 and later]
	0 = connector K0000
	1 = connector K0001
	etc.

10-62	SIEMENS Energy & Automation
	SIMOREG DC Master Base Drive Panel Operating Instructions