Siemens 6RA70 specifications 10-83, See Change Access / Status P803 Baud rate for G-SST3

PNU

Description

Value range [Unit] Steps

No. indices Factory setting Type

See Change (Access / Status)

P803	Baud rate for G-SST3
*	1	300 baud
(G172)
	2	600 baud
(G174)
	3	1200 baud
	4	2400 baud
	5	4800 baud
	6	9600 baud
	7	19200 baud
	8	38400 baud
	9	56700 baud
	11	93750 baud
	13	187500 baud

P804	Source for transmit data for G-SST3
*	Selection of connectors to be transferred as transmit data via basic
(G172)
	converter interface 3
(G174)
	When USS protocol (P800=2) is selected:
	i001:	Selection for word 1
	i002:	Selection for word 2
	...
	i016:	Selection for word 16
	When peer-to-peer (P800=5) is selected:
	i001:	Selection for word 1
	i002:	Selection for word 2
	...
	i005:	Selection for word 5
	i006:	Not used
	...
	i016:	Not used
	Applicable settings:
	0 = connector K0000
	1 = connector K0001
	etc.
P805	Options for G-SST3
(G172)	i001:	0 = Bus terminator OFF
		1 = Bus terminator ON
(G174)	i002:	0 = Bit 10 of the 1st receive word does not function as "Control
		by PLC".
		1 = Bit 10 of the 1st receive word does function as "Control by
		PLC“, i.e. when bit 10 = 0, all other bits of the 1st receive word,
		as well as receive words 2 to 16, are not written to connectors
		K9001 to K9016, or to binectors B9100 to B9915. All these
		connectors and binectors retain their old values.
P806	USS bus address for G-SST3
*	This parameter is functional only when P800=2 (USS protocol). Address via
(G172)
	which the unit can be addressed in USS bus operation.

1 to 13

1

All connector numbers

1

0 to 1

1

0 to 30

1

Ind: None	P052	= 3
FS=13	P051	= 40
Type: O2	Offline

Ind: 16	P052	= 3
FS=	P051	= 40
i001: 32	Offline
i002: 167
i003: 0
i004: 33
i005-i016: 0
Type: L2

Ind: 2	P052	= 3
FS=0	P051	= 40
Type: O2	Offline

Ind: None	P052	= 3
FS=0	P051	= 40
Type: O2	Offline

SIEMENS Energy & Automation	10-83
SIMOREG DC Master Base Drive Panel Operating Instructions