Toshiba VF-AS1 instruction manual Stop position control function, Setting motor constants

E6581301

The characteristic of the feedback value can also be reversed by means of a signal from an external device.

Example: To use the S3 terminal as a PID normal/reverse characteristic switching signal input terminal

Title	Function	Adjustment range	Default setting
￿￿￿￿￿	Input terminal function selection7(S3)	￿~￿￿￿	￿￿ (positive logic)
			￿￿ (negative logic)

6) Setting the time elapsed before PID control starts

You can specify a waiting time for PID control to prevent the inverter from starting PID control before the control system becomes stable, for example, after start-up.

The inverter ignores feedback input signals, carries out operation at the frequency determined by the value of processing for the time specified by ￿￿￿￿"and enters the PID control mode after a lapse of the specified time.

6.21		Stop position control function
		￿ ￿￿￿	: V/f control mode selection	￿￿￿￿￿￿	: Number of PG input pulses￿
		￿￿￿￿￿￿	: PID control switching	￿￿￿￿￿￿	: Selection of number of PG
		￿￿￿￿￿￿	: PID control feedback control		input phases￿
			signal selection	￿￿￿￿￿￿	: Simple positioning
		￿￿￿￿￿￿	: Proportional (P) gain		completion range
6	￿ For details, see Instruction Manual (E6581319) specified in Section 6.42.
6.22		Setting motor constants

￿￿￿￿: Auto-tuning 1

￿￿￿￿: Slip frequency gain

￿￿￿￿: Auto-tuning 2

￿￿￿￿: Motor rated capacity (motor nameplate)

￿￿￿￿: Motor rated current (motor nameplate)

￿￿￿￿: Motor rated rotational speed (motor nameplate)

￿￿￿￿: Motor constant 1 (torque boost)

￿￿￿￿: Motor constant 2 (no-load current)

￿￿￿￿: Motor constant 3 (leak inductance)

￿￿￿￿: Motor constant 4 (rated slip)

When selecting automatic torque boost and vector control (i.e., when setting the parameter ￿￿ to ￿, ￿, ￿, ￿ or ￿. By default, ￿￿ is set to ￿￿(v/f constant control)), be sure to set every parameter concerned in accordance with the flowchart on the next page.

Warning

	The inverter is tuned automatically (auto-tuning ￿￿￿￿=￿) when the inverter is started for the first time
	after setup. During auto-tuning, which takes about 3 minutes from several seconds as each model, the
	motor is energized, although it is standing still.
Prohibited
	Provide cranes and hoists with sufficient circuit protection such as mechanical braking.
	Without sufficient circuit protection, the resulting insufficient motor torque during tuning could create a risk
	of machine stalling/falling.
	Be sure to set every parameter concerned in accordance with the flowchart on the next page. Failure to
Mandatory	do this may cause the inverter not to control the motor properly, and therefore cause the motor not to
	deliver the desired performance.

F-38