Toshiba VF-AS1 Preset speed operation, Set this parameter at terminal board Any setting is valid

E6581301

!The functions assigned to the following control input terminals (contact input: ￿ Refer to Section 7.2) are always activated regardless of the settings of the command mode selection ￿￿￿￿ and frequency setting mode selection

1￿￿￿￿.

•Reset terminal (default setting: RES, valid only for tripping)

•Standby terminal (assigned to ST by default)

•Emergency stop terminal

!To make changes in the command mode selection ￿￿￿￿ and the frequency setting mode selection 1 ￿￿￿￿

first stop the inverter temporarily.

No change can be made to them if the inverter is in operation.

■Preset speed operation

￿￿￿￿: Set this parameter at ￿ (terminal board).

￿￿￿￿: Any setting is valid.

1) Setting the run, stop and operation frequencies with the operation panel

Title	Function	Example of setting
￿￿￿￿	Command mode selection	￿ (Operation
		panel input)
￿￿￿￿	Frequency setting mode	￿ (Operation
	selection 1	panel input)

5

Run/stop :Press the RUN and STOP keys

on the operation panel

!To switch between forward run and reverse run, use the forward/reverse run selection ￿￿.

Speed command :Press the and

keys on the operation

panel to set the frequency.

				Motor
Power	R/L1		U/T1	IM
supply	S/L2		V/T2
	T/L3		W/T3
			F
		Inverter
			R
			ST	Shorted by a shorting bar when
			CC	shipped from the factory.
	CCA	RX	VI/II RR/S4 PP	(-H1,HN,WN products.)

To save the frequency, press the ENTER key. Then, ￿￿ and the set frequency are displayed alternately for a while.

E-8