! E6581301!

G-5

7
■ Sink logic/source logic
Switching between sink logic and source logic (input/output terminal l ogic) is possible.
For details, refer to the Section 2.3.2.
7.2.2 Functions of output terminals (incase of sink logic)
Use the above parameters to send various signals from the inverter to e xternal equipment.
By setting parameters for the OUT1, OUT2 and FL (FLA, FLB and FLC) terminals on the terminal board, you can use
0~255 functions and functions obtained by combining them.
[Control terminal board]
■ How to use
Function of OUT1··········To be set by parameter H
Function of OUT2··········To be set by parameter H
Functions of FLA, FLB, and FLC··········To be set by parameter H
■ Setting of output terminal function
Terminal
symbol Title Function Adjustment range Default setting
OUT1 H Output terminal function
selection 1 ~ 
(Low-speed signal)
OUT2 H
Output terminal function
selection 2 ~

(Acceleration/decele
ration completion)
FL H Output terminal selection 3 ~ 
(Failure FL)
OUT3~OUT6
R1~R2
H
~
H
Output terminal function
selection 4~9 ~ 
R3, R4 H, H
Output terminal function
selection 10~11 ~ 
Note1: H~H is for use of expansion terminal board 1 option unit.
Note2: H~H is for use of expansion terminal board 2 option unit.
Note3: H, H is not supported (for options).
Note4: When use OUT1 terminal for pulse output function, refer to Section 6. 35.1.

FLA
FLB
P24
OUT1
FLC
OUT2
Ry
Ry
NO
CC