Toshiba VF-AS1 How to set parameters, Setting parameters in the selected quick mode

! !E6581301

4.1How to set parameters

This section explains how to set parameters, while showing how parameters are organized in each setting monitor mode.

4.1.1 Setting parameters in the selected quick mode

To place the inverter in this mode, press the EASY key (the LED lights up), and then press the MODE key.

Note that extended parameters are not displayed in the quick mode.

Standard monitor mode

4

8 kinds of standard parameter are displayed

Enter key

Used to set values

and return to previous menu

Quick mode (EASY)

Title			Function
￿￿￿￿	Automatic function setting
￿￿￿	V/f control mode selection
￿￿￿		Maximum frequency
￿￿￿￿		Acceleration time 1
￿￿￿￿		Deceleration time 1
￿￿￿￿	Motor electronic thermal protection level 1
￿￿￿	FM terminal meter adjustment
￿￿￿￿￿	Registered parameter display selection
				Basicparameter
	*
				setting

*Parameter title and the setting value are displayed alternately.

Select key	Mode key
Used to select	Used to select mode
item	and operation level

■ How to set basic parameters
(1) Selects parameter to be changed. (Press the	or	key.)

(2)Reads the programmed parameter setting. (Press the ENT key.)

(3)Change the parameter value. (Press theor key.)

(4)Press this key to save the change. (Press the ENT key.)

■Adjustment range and display of parameters

￿￿: An attempt has been made to assign a value that is higher than the programmable range. Or, as a result of changing other parameters, the programmed value of the parameter that is now selected exceeds the upper limit.

￿￿: An attempt has been made to assign a value that is lower than the programmable range. Or, as a result of changing other parameters, the programmed value of the parameter that is now selected exceeds the lower limit.

If the above alarm is flashing on and off, no setting can be done of values that are equal to or greater than ￿￿ or equal to or lower than ￿￿.

D-2