Operational Features

Configurable Indication of Terminated Calls

An Administrator can configure a parameter called, far-end disconnect timer” which allows you to enable or disable whether or not the near-end phone displays a disconnected screen with a “Call Terminated” message when the far-end hangs up. An audible busy signal is also heard on the phone. If enabled with a maximum time interval value, this parame- ter also specifies the interval of time that the busy signal is audible.

You can enable/disable this new parameter using the configuration files only.

The following table identifies when a call terminated screen displays on the phone for different scenarios.

IF

THEN

1 line active and far-end disconnects,

the line in focus:

 

displays disconnected screen.

 

plays busy tone.

 

displays "Call Terminated" message on the screen.

 

the line not in focus:

 

plays busy tone.

 

 

2 or more lines active, and far-end disconnects,

the line in focus:

 

displays disconnected screen.

 

plays busy tone.

 

displays "Call Terminated" message on the screen for 5 seconds. When 5

 

 

second times out:

 

 

- the busy tone stops

 

 

- the disconnected screen disappears.

 

 

 

2 or more lines active, and a line NOT in focus is disconnected by the far-

no busy tone plays

end,

no disconnected screen displays

 

no “Call Terminated” message displays

 

 

 

An incoming call comes in on the line in focus that has a disconnected

the line in focus with no calls on hold:

screen displaying,

 

- displays a ringing screen

 

the line in focus WITH calls on hold:

 

 

- flashes its’ Line LED

 

 

 

An incoming call comes in on another line (NOT in focus), and the dis-

the disconnected screen no longer displays on the line in focus.

connected screen is displaying on the line in focus,

 

 

 

 

 

A phone application is NOT in focus,

busy tone plays

 

no disconnected screen displays

 

When the phone application in focus on screen stops:

- busy tone plays

- disconnected screen displays

Note:

This “indication of terminated calls” feature does not affect parked calls on the phone or the conference call feature.

Configuring Indication of Terminated Calls

You can enable or disable whether or not the phone displays an indication of a terminated call using the parameter, “far- end disconnect timer.” This parameter also specifies the maximum time interval that the busy tone is audible on the phone. You can configure the indication of terminated calls using the configuration files only.

Use the following procedure to configure this feature.

Configuration Files

For specific parameters you can set in the configuration files, see Appendix A, the section, “Terminated Calls Indicator” on page A-150.

41-001343-02 REV04 – 05.2014

5-267

Page 507
Image 507
Aastra Telecom 41-001343-02 manual Configurable Indication of Terminated Calls, Configuring Indication of Terminated Calls