Aastra Telecom 41-001343-02 manual Configuring Vlan optional, Select Admin Menu

Network Settings

IP Phone UI

6.Press the Save softkey.

7.Restart the phone for the selection to take affect.

Aastra Web UI

1.Click on Advanced Settings->Network->Type of Service DSCP.

2.Select a Protocol field:

• “SIP”

or

•“RTP”

or

•“RTCP”

3.Enter a value from 0 to 63. Default values are as follows:

•SIP = 26

•RTP = 46

•RTCP = 46

Note:

If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled, you will need to map the applicable priority to the Protocol setting as shown in the first table in “DSCP Range/VLAN Priority Mapping” on page 4-42.For more information, see the section “Configuring VLAN (optional)” on page 4-45.

4.Click Save Settings to save your settings.

Configuring VLAN (optional)

Use the following procedures to configure VLAN on the IP phone.

Notes:

•VLAN is disabled by default. When you enable VLAN, the IP phones use the default settings for each VLAN parameter. You can change the default settings if required using the following procedure.

•PC Port parameters are not applicable to the 6730i IP Phone.

Configuration Files

For specific parameters you can set in the configuration files, see Appendix A, the section, “Virtual Local Area Network (VLAN) Settings” on page A-34.

IP Phone UI

1.	on the phone to enter the Options List.
Press

2.Select Admin Menu.

41-001343-02 REV04 – 05.2014 4-45