Aastra Telecom 41-001343-02 6757i Cordless CT Feature Keys, Feature Key Programming Guidelines

Operational Features

Configuring the Increase of Displayed Characters for Softkey Line Labels

Use the following parameter to disable the line icon and increase the number of characters displayed for softkey line labels:

Configuration Files

For specific parameters you can set in the configuration files, see Appendix A, the section, “Increase of Displayed Characters for Softkey Line Labels” on page A-165.

6757i Cordless (CT) Feature Keys

In addition to the softkeys on the 6757i CT, this phone also has handset keys you can configure with specific features. You can use the Aastra Web UI to configure the handset keys.

Note:

You configure the handset keys using the Aastra Web UI (Operation->Handset Keys) or by pressing the "F" button on the handset.

You can program up to 15 feature keys on the 6757i CT handset with specific functions using the Aastra Web UI.

The following table identifies the functions available for all 15 handset keys and the default functions for each key.

Handset Key	Key Function	Description
1	Line 1	Line 1 key - Selects line one
2	Line 2	Line 2 key - Selects line two
3	Line 3	Line 3 key - Selects line three
4	Line 4	Line 4 key - Selects line four
5	Icom	Icom key – Enter handset list to select handset to call
6	Dir	Directory key – Activate directory feature
7	Callers	Callers key – Activate callers feature
8	Xfer	Transfer key - Activate transfer feature
9	Conf	Conference key - Activate conference feature
10	Public	Public key – Toggle between public & private call mode
11	None	No function selected. Line 5 key (if available) - Selects line five.
12	None	No function selected. Line 6 key (if available) - Selects line six.
13	None	No function selected. Line 7 key (if available) - Selects line seven.
14	None	No function selected. Line 8 key (if available) - Selects line eight.
15	None	No function selected. Line 9 key (if available) - Selects line nine.

Feature Key Programming Guidelines

The following are guidelines to use when programming the feature keys on the handset:

•All handsets paired with the same Base Station have the same programmed functions since the web interface applies the functions to all the handsets paired with that base.

•A newly registered handset or handset that was out-of-range during the programming needs to perform an "off-hook

and on-hook" sequence in order for the newly programmed function to be broadcasted to the affected handsets. Simply press the vkey from the idle state to go off-hook. Then, press the y key to go back on-hook.

•Duplicate functions can exist in the feature key as there is no filtering or duplicate checking done on the handset or

5-118 41-001343-02 REV04 – 05.2014