XS712T Smart Switch

IP Configuration

Use the IP Configuration screen to configure routing parameters for the switch.

To enable routing on the switch:

1.Select Routing > IP > IP Configuration.

2.Next to Routing Mode, select Enable.

You must enable routing for the switch before you can route through any of the interfaces. Routing is also enabled or disabled per VLAN interface. The default value is Disable.

The following table describes the IP configuration information displayed on the screen.

Field

Description

Default Time to Live

The default value inserted into the Time-To-Live field of the IP

 

header of datagrams originated by the switch, if a TTL value is not

 

supplied by the transport layer protocol. The default value is 64.

 

 

Maximum Next Hops

The maximum number of hops supported by the switch. This is a

 

compile-time constant. The default value is 1.

3.Click Apply.

IP Statistics

The statistics reported on the IP Statistics screen are as specified in RFC 1213.

To display the IP statistics screen:

Select Routing > IP >Statistics. The IP Statistics screen displays.

138

Page 138
Image 138
NETGEAR XS712T-100NES manual IP Statistics,  To display the IP statistics screen, 138