XS712T Smart Switch

Dual Image Configuration

The system running a legacy software version will ignore (not load) a configuration file created by the newer software version. When a configuration file created by the newer software version is discovered by the system running an older version of the software, the system will display an appropriate warning to the user.

Use the Dual Image Configuration screen to set the boot image, configure an image description, or delete an image.

To configure dual image settings:

1. Select Maintenance > File Management > Dual Image > Dual Image Configuration.

2.In the Image Name field, select one of the images.

The Current-active field displays the name of the active image.

3.In the Image Description field, type a description.

4.To set the selected image as the active image, select the Activate Image check box.

Note: After activating an image, you must perform a system reset of the switch to run the new code.

5.To remove the selected image from permanent storage on the switch, select the Delete Image check box.

You cannot delete the active image.

6.Click Apply.

267

Page 267
Image 267
NETGEAR XS712T-100NES manual Dual Image Configuration, 267