Initial Tab Copy Setting

This is used to set the default image shift width (tab width) for tab copying.

The default width can be set from 0" (0 mm) to 5/8" (20 mm) in increments of 1/8" (1 mm).

Disabling Deletion of Job Programs

This is used to prohibit the deletion and changing of copy settings stored in job programs.

Disabling of Bypass-Tray in Duplex Copy

This is used to prohibit the use of the bypass tray when making two-sided copies.

The bypass tray is often used to feed label sheets, transparency film, and other special media for which two-sided copying is prohibited. If a sheet of one of these special media enters the reversing unit, a misfeed or damage to the unit may result. If special media for which two-sided copying is prohibited is often used, it is recommended that you enable this setting.

Disabling of Auto Paper Selection

This setting is used to disable the Auto Paper Selection function.

When this setting is enabled, automatic selection of paper that is the same size as the original on the document glass or in the automatic document feeder does not take place.

Auto Selection Setting of Tray that is Supplied the Paper

When this setting is enabled and paper is loaded in a tray while the machine is on standby in copy mode, that tray is automatically selected.

600dpi x 600dpi Scanning Mode for Document Feeder

The resolution used when scanning originals on the document glass can be set to 600 x 600 dpi (high quality mode).

When this setting is disabled, originals are scanned at 600 x 300 dpi.

When high quality mode is used, fine print and thin lines are reproduced with greater clarity, however, the scanning speed is slower.

When this setting is enabled to give priority to job speed, the following conditions must all be met in order for scanning to take place at the set resolution.

•The copy ratio must be set to 100%.

•Do not select a special mode that will change the ratio.

Quick Scan from Document Glass

The resolution used when scanning originals on the document glass can be set to 600 x 300 dpi (speed priority mode).

When this setting is disabled, originals are scanned at 600 x 600 dpi.

When high speed mode is selected, the first copy time is quicker, however, the copy image is not as clear.

When this setting is disabled to give priority to job speed, the following conditions must all be met in order for scanning to take place at the set resolution.

•The copy ratio must be set to 100%.

•Do not select a special mode that will change the ratio.

48