Network Settings
Network settings are described below. Touch the [Network Settings] key to configure the settings.
When any of these settings are changed, you must exit the system settings, turn off the [POWER] key (
), wait a brief interval, and then turn the [POWER] key ( 
) back on to make the new settings take effect.
IP Address Setting
When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP address of the machine.
The settings are shown below.
IP Address
Enter the IP address of the machine.
IP Subnet Mask
Entry the IP Subnet Mask.
IP Gateway
Enter the IP Gateway address.
DHCP
Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol). When this setting is enabled, it is not necessary to manually enter an IP address.
• If the machine will be used on a TCP/IP network, be sure to enable "Enable TCP/IP" below.
•If DHCP is used, the IP address assigned to the machine may change automatically. If the IP address changes, printing will not be possible.
Enable TCP/IP
To use the machine on a TCP/IP network, this setting must be enabled.
Enable NetWare
To use the machine on a NetWare network, this setting must be enabled.
49