Lucent Technologies 555-230-024 manual Trademarks

Copyright © 1997, Lucent Technologies

All Rights Reserved

Printed in U.S.A.

Notice

Every effort was made to ensure that the information in this book was complete and accurate at the time of printing. However, information is subject to change.

Your Responsibility for Your System’s Security

Toll fraud is the unauthorized use of your telecommunications system by an unauthorized party, for example, persons other than your com- pany’s employees, agents, subcontractors, or persons working on your company’s behalf. Note that there may be a risk of toll fraud associ- ated with your telecommunications system and, if toll fraud occurs, it can result in substantial additional charges for your telecommunica- tions services.

You and your system manager are responsible for the security of your system, such as programming and configuring your equipment to pre- vent unauthorized use. The system manager is also responsible for reading all installation, instruction, and system administration docu- ments provided with this product in order to fully understand the fea- tures that can introduce risk of toll fraud and the steps that can be taken to reduce that risk. Lucent Technologies does not warrant that this product is immune from or will prevent unauthorized use of com- mon-carrier telecommunication services or facilities accessed through or connected to it. Lucent Technologies will not be responsible for any charges that result from such unauthorized use.

Lucent Technologies Fraud Intervention

If you suspect that you are being victimized by toll fraud and you need technical support or assistance, call Technical Service Center Toll Fraud Intervention Hotline at 1 800 643-2353.

Federal Communications Commission Statement

Part 15: Class A Statement. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide rea- sonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer- ence to radio communications. Operation of this equipment in a resi- dential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense.

Part 68: Network Registration Number. This equipment is regis- tered with the FCC in accordance with Part 68 of the FCC Rules. It is identified by FCC registration number AS593M-13283-MF-E.

Part 68: Answer-Supervision Signaling. Allowing this equipment to be operated in a manner that does not provide proper answer-supervi- sion signaling is in violation of Part 68 Rules. This equipment returns answer-supervision signals to the public switched network when:

•Answered by the called station

•Answered by the attendant

•Routed to a recorded announcement that can be administered

by the CPE user

This equipment returns answer-supervision signals on all DID calls forwarded back to the public switched telephone network. Permissible exceptions are:

•A call is unanswered

•A busy tone is received

•A reorder tone is received

Canadian Department of Communications (DOC) Interference Information

This digital apparatus does not exceed the Class A limits for radio noise emissions set out in the radio interference regulations of the Canadian Department of Communications.

Le Présent Appareil Nomérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A préscrites dans le reglement sur le brouillage radioélectrique édicté par le ministére des Communications du Canada.

Trademarks

See the preface of this document.

Ordering Information

Call: Lucent Technologies Publications Center

Voice 1 800 457-1235 International Voice 317 361-5353

Fax 1 800 457-1764 International Fax 317 361-5355

Write: Lucent Technologies Publications Center P.O. Box 4100

Crawfordsville, IN 47933

Order: Document No.555-230-024 Comcode 108136169 Issue 5 January 1998

For additional documents, refer to Appendix D, “References.”

You can be placed on a standing order list for this and other docu- ments you may need. Standing order will enable you to automatically receive updated versions of individual documents or document sets, billed to account information that you provide. For more information on standing orders, or to be put on a list to receive future issues of this document, contact the Lucent Technologies Publications Center.

European Union Declaration of Conformity

The “CE” mark affixed to the DEFINITY® equipment described in this book indicates that the equipment conforms to the following Euro- pean Union (EU) Directives:

•Electromagnetic Compatibility (89/336/EEC)

•Low Voltage (73/23/EEC)

•Telecommunications Terminal Equipment (TTE) i-CTR3 BRI

and i-CTR4 PRI

For more information on standards compliance, contact your local dis- tributor.

Comments

To comment on this document, return the comment card at the front of the document.

Acknowledgment

This document was prepared by Product Publications, Lucent Technologies,

Denver, Colorado.