Mode Function
automatically initiates negotiation with other ports by
initiating LACP packets.
passive An interface is not in an active negotiating state in this
mode. LACP runs on any link configured in the passive state.
Ports in a passive state respond to negotiation requests from
other ports that are in active states. Ports in a passive state
respond to LACP packets
off An interface cannot be part of a dynamic port channel in off
mode. LACP does not run on a port configured in off mode.
port-channel-protocol lacp
Enable LACP on any LAN port.
Z9500
Syntax port-channel-protocol lacp
To disable LACP on a LAN port, use the no port-channel-protocol lacp
command.
Command
Modes
INTERFACE
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
6.2.1.1 Introduced on the E-Series.
Related
Commands show lacp — displays the LACP information.
show interfaces port-channel — displays information on configured Port Channel
groups.
1134 Link Aggregation Control Protocol (LACP)