ipv6 ipv6-address interface interface-type | interface-number
lease valuecommand.
Parameters mac address Enter the keyword mac then the MAC address of the host to
which the server is leasing the IPv6 address.
vlan-id Enter the keywords vlan-id then the VLAN to which the
host belongs. The range is from 2 to 4094.
ipv6 ipv6-
address
Enter the keyword ipv6 then the IPv6 address that is leased
to the client.
interface type Enter the keyword interface then the type of interface to
which the host is connected:
• For an 10/100 Ethernet interface, enter the keyword
fastethernet.
• For a Gigabit Ethernet interface, enter the keyword
gigabitethernet.
• For a Ten-Gigabit Ethernet interface, enter the keyword
tengigabitethernet.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE.
interface
number
Enter the number of the interface.
lease value Enter the keyword lease then the amount of time the IPv6
address are leased. The range is from 1 to 4294967295.
Defaults none
Command
Modes • EXEC Privilege
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S4810, S4820T, S6000 and Z-Series.
ip dhcp snooping database
Delay writing the binding table for a specified time.
Z9500
Syntax ip dhcp snooping database write-delay minutes
728 Dynamic Host Configuration Protocol (DHCP)