Command
Modes
INTERFACE
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage
Information The dot1p-priority command changes the priority of incoming traffic on the
interface. The system places traffic marked with a priority in the correct queue and
processes that traffic according to its queue.
When you set the priority for a port channel, the physical interfaces assigned to the
port channel are configured with the same value. You cannot assign the dot1p-
priority command to individual interfaces in a port channel.
rate police
Police the incoming traffic rate on the selected interface.
Z9500
Syntax rate police [kbps] committed-rate [burst-KB] [peak [kbps] peak-
rate [burst-KB]] [vlan vlan-id]
Parameters kbps Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps).
committed-
rate
Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16
to 200000. The default is 50.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to
specify the peak rate in Mbps. The range is from 0 to 40000.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then a VLAN ID to
police traffic to those specific VLANs. The range is from 1 to
4094.
Quality of Service (QoS) 1483