Interfaces supported by IS-IS:
TenGigabitEthernet 1/1 - IP - IPv6
TenGigabitEthernet 1/2 - IP - IPv6
TenGigabitEthernet 1/10 - IP - IPv6
Loopback 0 - IP - IPv6
Redistributing:
Distance: 115
Generate narrow metrics: level-1-2
Accept narrow metrics: level-1-2
Generate wide metrics: none
Accept wide metrics: none
Multi Topology Routing is enabled in transition mode.
Dell#
show isis traffic
This command allows you to display IS-IS traffic interface information.
Z9500
Syntax show isis [vrf vrf-name] traffic [interface]
Parameters vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to display IS-IS traffic interface information
corresponding to that VRF.
interface (OPTIONAL) Identifies the interface type slot/port as one of
the following:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command
Modes • EXEC
• EXEC Privilege
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1124 Intermediate System to Intermediate System (IS-IS)