Example (2
Summary)
Dell#show frrp 2 summary
Dell#show frrp 2 summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
-----------------------------------------------
2 Up Master 2 11-20, 25, 27-30
Dell#
Related
Commands
protocol frrp — enters the resilient ring protocol and designate a ring identification.
timer
Set the hello interval or dead interval for the Ring control packets.
Syntax timer {hello-interval milliseconds}| {dead-interval
milliseconds}
To remove the timer, use the no timer {hello-interval
[milliseconds]}| {dead-interval milliseconds} command.
Parameters hello-interval
milliseconds
Enter the keyword hello-interval then the time, in
milliseconds, to set the hello interval of the control packets.
The milliseconds must be entered in increments of 50
millisecond; for example, 50, 100, 150, and so on. If an
invalid value is entered, an error message is generated. The
range is from 50 to 2000 ms. Default: 500 ms.
dead-interval
milliseconds
Enter the keyword dead-interval then the time, in
milliseconds, to set the dead interval of the control packets.
The range is from 50 to 6000 ms. Default: 1500 ms.
NOTE: The configured dead interval must be at least
three times the hello interval.
Defaults •500 ms for hello-interval milliseconds
•1500 ms for dead-intervalmilliseconds
Command
Modes
CONFIGURATION (conf-frrp)
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
790 Force10 Resilient Ring Protocol (FRRP)