Related
Command
vrrp delay minimum — sets the delay time for VRRP initialization after a line card
reboot.
vrrp-group
Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
Z9500
Syntax vrrp-group vrrp-id
Parameters vrrp-id Enter a number as the group ID. The range is from 1 to 255.
Defaults Not configured.
Command
Modes
INTERFACE
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP
address is configured. When you delete the virtual address, the VRRP group stops
sending VRRP packets.
Related
Command
virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
Virtual Router Redundancy Protocol (VRRP) 1899