type-1 Enter the keyword type-1 to assign the OSPF Type 1 metric.
type-2 Enter the keyword type-2 to assign the OSPF Type 2 metric.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Implemented the keyword internal.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Related
Commands set automatic-tag — computes the tag value of the route.
set level — specifies the OSPF area for route redistribution.
set metric — specifies the metric value assigned to redistributed routes.
set tag — specifies the tag assigned to redistributed routes.
set next-hop
To specify an IP address as the next hop, configure a filter.
Z9500
Syntax set next-hop ip-address
To delete the setting, use the no set next-hop ip-address command.
Parameters ip-address Specify an IP address in dotted decimal format.
Access Control Lists (ACL) 327