Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information You can only configure one domain name with the ip domain-name command.
To configure more than one domain name, configure the ip domain-list
command up to six times.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command.
Related
Commands ip domain-list — configures additional names.
ip helper-address
Specify the address of a DHCP server so that DHCP broadcast messages can be forwarded when the
DHCP server is not on the same subnet as the client.
Z9500
Syntax ip helper-address ip-address
To remove a DHCP server address, use the no ip helper-address command.
Parameters ip-address Enter an IP address in dotted decimal format (A.B.C.D).
Defaults Not configured.
Command
Modes
INTERFACE
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
946 IPv4 Routing