guestuser
Dell(conf)#
Example Dell(conf)# ip access-list standard snmp-ro-acl
Dell(config-std-nacl)#seq 5 permit host 10.10.10.224
Dell(config-std-nacl)#seq 10 deny any count
!
Dell(conf)#snmp-server community guest ro snmp-ro-acl
Dell(conf)#
Related
Commands ip access-list standard — names (or selects) a standard access list to filter based on
IP address.
ipv6 access-list — configures an access list based on IPv6 addresses or protocols.
show running-config — displays the current SNMP configuration and defaults.
snmp-server contact
Configure contact information for troubleshooting this SNMP node.
Z9500
Syntax snmp-server contact text
To delete the SNMP server contact information, use the no snmp-server
contact command.
Parameters text Enter an alphanumeric text string, up to 55 characters long.
Defaults none
Command
Modes
CONFIGURATION
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
1712 Simple Network Management Protocol (SNMP) and Syslog