Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
Syslog messages contain the IP address of the interface used to egress the router.
By configuring the logging source-interface command, the Syslog packets
contain the IP address of the interface configured.
Related
Commands logging — enables logging to the Syslog server.
logging synchronous
Synchronize unsolicited messages and output.
Z9500
Syntax logging synchronous [level level | all] [limit number-of-
buffers]
To disable message synchronization, use the no logging synchronous [level
level | all] [limit number-of-buffers] command.
Parameters all Enter the keyword all to ensure that all levels are printed
asynchronously.
level level Enter the keyword level then a number as the severity
level. A high number indicates a low severity level and vice
versa. The range is from 0 to 7. The default is 2.
all Enter the keyword all to turn off all.
limit number-
of-buffers
Enter the keyword limit then the number of buffers to be
queued for the terminal after which new messages are
dropped. The range is from 20 to 300. The default is 20.
Defaults Disabled. If enabled without the level or number-of-buffers options specified,
level = 2 and number-of-buffers = 20 are the defaults.
Command
Modes
LINE
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
Simple Network Management Protocol (SNMP) and Syslog 1743