Example
(History) Dell#show logging history
Syslog History Table: 1 maximum table entries,
saving level warnings or higher
SNMP notifications not Enabled
Feb 18 01:16:57: %SYSTEM:CP %SEC-3-
AUTHENTICATION_ENABLE_SUCCESS: Enable password authentication
success on vty0 ( 10.16.127.145 )
show logging auditlog
Displays an audit log.
Syntax show logging auditlog
Defaults none
Command
Modes
EXEC
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Example Dell(conf)#show logging audit
Related
Commands
clear logging auditlog — clears audit log.
show logging driverlog
Display the driver log for the specified hardware component.
Z9500
Syntax show logging driverlog {cp | rp | linecard slot-id}
Parameters cp Enter the keyword cp to display the driver log for the Control
Processor on the switch.
rp Enter the keyword cp to display the driver log for the Route
Processor on the switch.
1748 Simple Network Management Protocol (SNMP) and Syslog