POLICY-OUT mode supersedes the service-class bandwidth-percentage
command.
service-class dot1p-mapping
Configure a service-class criterion based on a dot1p value.
Z9500
Syntax service-class dot1p-mapping {dot1p0 value | dot1p1 value |
dot1p2 value | dot1p3 value | dot1p4 value| dot1p5 value |
dot1p6 value | dot1p7 value}
Parameters dot1p0 value ...
dot1p7 value
Enter a dot1p list number and value. The list number range is
from 0 to 7. The range is from 0 to 3.
Defaults For each dot1p Priority, the default CoS queue value is:
• dot1p Priority: 0 1 2 3 4 5 6 7
• CoS Queue: 2 0 1 3 4 5 6 7
Command
Modes
CONFIGURATION
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To apply dot1p-queue-mapping, use the service-class dynamic dot1p
command.
Related
Commands
show qos dot1p-queue-mapping — displays the dot1p priority to queue mapping
on the switch.
Quality of Service (QoS) 1475